HP StorageWorks 2/16V Brocade Fabric OS Message Reference Guide (53-1000242-01 - Page 412

58 SEC-1074 SEC-1074 Message , [SEC-1074], ,, ERROR, , Cannot execute the command on this switch. Please check the secure mode and FCS status. Probable Cause Recommended Action Severity Indicates that a security command was run on a switch that is not allowed to run it either because it is in non-secure mode or because it does not have required FCS privilege. If a security operation that is not allowed in non-secure mode is attempted, do not perform the operation in non-secure mode. In secure mode, run the command from a switch that has required privilege, that is, either a backup FCS or primary FCS. ERROR SEC-1075 Message , [SEC-1075], ,, ERROR, , Fail to new policy set on all switches. Probable Cause Recommended Action Severity Indicates that there has been a corruption during the distribution of the security database. This can only occur when the primary FCS is distributing the security database to the other switches in the fabric and local validation finds that there is an error in the security database. This is a rare occurrence. Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be in the ready state. If a switch is in the error state, the database might not be correctly updated for that specific switch. ERROR SEC-1076 Message , [SEC-1076], ,, ERROR, , NoNodeWWNZoning option has been changed. Probable Cause Recommended Action Severity Indicates that the NoNodeWWNZoning option has been changed. If the option is turned on, a zone member can be added using node WWNs, but the member will not be able to communicate with others nodes in the zone. Reenable the current zone configuration for the change to take effect. ERROR 58-18 Fabric OS Message Reference Publication Number: 53-1000242-01