HP StorageWorks 2/16V Brocade Fabric OS Message Reference Guide (53-1000242-01 - Page 99

BL-1016 3 Severity On a bladed switch, run the slotPowerOff and slotPowerOn commands. On a nonbladed switch, reboot the switch. Run the systemVerification command to determine if there is a hardware error. If there is a hardware error, if the slotPowerOff or slotPowerOn fails on the bladed switch or if errors are encountered again: • On the SilkWorm 12000, 24000, and 48000, replace the blade FRU. • On the SilkWorm 3900, replace the motherboard FRU. • On the SilkWorm 200E, 3016, 3250, 3850, or 4100, replace the switch. ERROR BL-1016 Message , [BL-1016], , FFDC, CRITICAL, , Blade port in slot failed to enable. Probable Cause Recommended Action Severity Indicates that the specified blade port has failed to get enabled. Make sure that the blade is seated correctly. If the blade is seated correctly, reboot or power cycle the blade. Run the systemVerification command to verify that the blade does not have hardware problems. Refer to the Fabric OS Command Reference for more information on this command. If the message persists, replace the blade. CRITICAL BL-1017 Message , [BL-1017], ,, INFO, , Slot Initializing... Probable Cause Recommended Action Severity Indicates that the slot has started initializing the ports. No action is required. INFO Fabric OS Message Reference 3-7 Publication Number: 53-1000242-01