HP StorageWorks 2/16V Brocade Fabric OS Message Reference Guide (53-1000242-01 - Page 552

79 SULB-1018 Recommended Action Severity Run the slotShow command. If the blade is in a Faulty state, run the slotPowerOff and slotPowerOn commands to that blade to trigger another firmwareDownload. If the blade is stuck in LOADING state, you need to remove and re-insert the blade to trigger another firmwareDownload. If the problem persists, contact your switch service provider. ERROR SULB-1018 Message AUDIT, , [SULB-1018], ERROR, FIRMWARE, , , , Firmwaredownload timed out in slot . Probable Cause Recommended Action Severity The error can be caused by unexpected disruption of firmwareDownload command, for example, powering off of the indicated BP blade in the middle of firmwareDownload. This error can also be caused by the persistent storage failure, or other hardware failures of the BP blade. Run the slotShow command. If the blade in in Faulty state, run the slotPowerOff and slotPowerOn commands to that blade to trigger another firmwareDownload. If the blade is stuck in LOADING state, you need to remove and re-insert the blade to trigger another firmwareDownload. If the problem persists, contact your switch service provider. ERROR SULB-1020 Message AUDIT, , [SULB-1020], ERROR, FIRMWARE, , , , New firmware failed to boot in slot . Probable Cause Recommended Action Severity The BP blade should reboot with the new image. However, it is still running the old image. This error can be caused because that new image has not been loaded properly to the indicated blade. Run the slotShow command. If the blade is in Faulty state, run the slotPowerOff and slotPowerOn commands to that blade to trigger another firmwareDownload. If the blade is stuck in LOADING state, you need to remove and re-insert the blade to trigger another firmwareDownload. If the problem persists, contact your switch service provider. ERROR 79-10 Fabric OS Message Reference Publication Number: 53-1000242-01