HP StorageWorks 2/16V Brocade Fabric OS Message Reference Guide (53-1000242-01 - Page 185

FCR-1057 18 Recommended Action Severity No action is required if backbone to edge routing is not needed. Otherwise replace the switch with one that supports backbone to edge routing. INFO FCR-1057 Message , [FCR-1057], ,, ERROR, , EX port() incompatible long distance parameters on link. Probable Cause Recommended Action Severity Indicates that the port, which is configured in long distance mode, has incompatible long distance parameters. Check the port configuration on both sides of the link using the portCfgShow command. Investigate the other switch for more details. Run the errShow command on the other switch to view the error log for additional messages. ERROR FCR-1058 Message , [FCR-1058], ,, WARNING, , Port isolated due to mismatched configuration parameter; . Probable Cause Recommended Action Severity Indicates that the specified port was isolated after segmentation, which was caused by mismatched configuration parameters. Please check the switches on both ends of the link for a possible mismatch in switch or port configuration parameters such as 'Operating Mode', EDTOV, or RATOV. Run the portCfgExport command to modify the appropriate parameters on the local switch. Run the appropriate configuration command to modify the switch or port parameters on the remote switch. WARNING FCR-1059 Message , [FCR-1059], ,, INFO, , EX port was disabled due to an authentication failure. Fabric OS Message Reference Publication Number: 53-1000242-01 18-17