HP StorageWorks 2/16V Brocade Fabric OS Message Reference Guide (53-1000242-01 - Page 133

EM-1046 9 Recommended Action Severity The SilkWorm 24000 (CP2) requires only a single power supply for a fully populated chassis; however, you should always operate the system with at least two power supplies for redundancy. For the SilkWorm 48000 (CP4), when there are no intelligent (AP) port blades installed, two power supplies are sufficient for redundancy; however, when one or more AP blades have been installed, four power supplies are required for complete redundancy. WARNING EM-1046 Message , [EM-1046], ,, WARNING, , Sysctrl reports error status for blade ID for the blade in slot Probable Cause Recommended Action Severity Indicates that the system controller encountered a blade with an unknown ID in the slot specified. If the blade ID listed is not correct, then the FRU header for the blade is corrupted and the blade must be replaced. WARNING EM-1047 Message , [EM-1047], ,, INFO, , CP in slot not faulty, CP ERROR deasserted Probable Indicates that the CP is no longer faulted. This message usually follows EM-1033. The new standby CP Cause is in the process of rebooting and has turned off the CP_ERR signal. Recommended No action is required. Action Severity INFO EM-1048 Message , [EM-1048], ,, INFO, , I2C access recovered: state Probable Indicates that the I2C bus problems have been resolved and I2C access to the FRU has become Cause available again. Fabric OS Message Reference Publication Number: 53-1000242-01 9-13