HP StorageWorks 2/16V Brocade Fabric OS Message Reference Guide (53-1000242-01 - Page 154

12 FABS-1005 Probable Cause Recommended Action Severity Indicates that an operation has been interrupted by a signal. This is usually an internal Fabric OS problem or file corruption. Reboot or power cycle the switch. WARNING FABS-1005 Message , [FABS-1005], ,, WARNING, , (= ) Probable Cause Recommended Action Severity Indicates that an unsupported operation has been requested. This is usually an internal Fabric OS problem or file corruption. The possible values for function name and description of problem are: fabsys_write: Unsupported write operation: process xxx where "xxx" is the process ID (PID), which could be any whole number. Reboot or power cycle the active CP (for modular systems) or the switch (for single-board systems). If the message persists, run the firmwareDownload command to update the firmware. WARNING FABS-1006 Message , [FABS-1006], ,, WARNING, , : object unit Probable Cause Recommended Action Indicates that there is no device in the slot with the specified object type ID in the system module record. This could indicate that a serious Fabric OS data problem on the switch. The possible values for function name and description of problem are: • setSoftState: bad object • setSoftState: invalid type or unit • media_sync: Media oid mapping failed • fabsys_media_i2c_op: Media oid mapping failed • fabsys_media_i2c_op: obj is not media type • media_class_hndlr: failed sending media state to blade driver If the message is isolated, monitor the error messages on the switch. If the error is repetitive or if the fabric failed, fail over or reboot the switch. 12-2 Fabric OS Message Reference Publication Number: 53-1000242-01