HP StorageWorks 2/16V Brocade Fabric OS Message Reference Guide (53-1000242-01 - Page 130

9 EM-1035 Severity Run the systemVerification command to verify that the switch does not have hardware problems. Refer to the Fabric OS Command Reference for more information on this command. If the message persists, replace the FRU. ERROR EM-1035 Message , [EM-1035], ,, ERROR, , 2 circuit paired Power Supplies are faulty, please check the AC main switch/circuit to see if it has power. Probable Cause Recommended Action Severity Suggests that since both Power Supplies associated with one of the 2 main circuits are present but faulty, maybe the circuit's switch has been turned off, or the AC power source has been interrupted for that circuit. The Switch side value is either "left" or "right" designating which circuit switch, facing the cable side of the chassis. The Switch side value indicates: • "left": controls the odd numbered power supply units. • "right": controls the even numbered power supply units. Check that the identified AC circuit switch is turned on, that the power cord is properly attached and undamaged, and that the power source is operating properly. ERROR EM-1036 Message , [EM-1036], ,, WARNING, , is not accessible. Probable Cause Recommended Action Severity Indicates that the specified FRU does not seem to be present on the switch. If the FRU is a WWN card, then default WWN and IP addresses are used for the switch. Reseat the FRU card. If the message persists, reboot or power cycle the switch. Run the systemVerification command to verify that the switch does not have hardware problems. Refer to the Fabric OS Command Reference for more information on this command. If the message persists, replace the FRU. WARNING 9-10 Fabric OS Message Reference Publication Number: 53-1000242-01