HP StorageWorks 2/16V Brocade Fabric OS Message Reference Guide (53-1000242-01 - Page 142

11 FABR-1003 FABR-1003 Message , [FABR-1003], ,, WARNING, , port : ILS bad size , wanted Probable Cause Recommended Action Severity Indicates that an internal link service (ILS) information unit of invalid size has been received. The neighbor switch has sent an invalid sized payload. Investigate the neighbor switch for problems. Run the errShow command on the neighbor switch to view the error log for additional messages. Check for a faulty cable or deteriorated SFP. Replace the cable or SFP if necessary. Run the portLogDumpPort command on both the receiving and transmitting ports. Run the fabStateShow command on both the receiving and transmitting switches. If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the supportSave command and contact your switch service provider. WARNING FABR-1004 Message , [FABR-1004], ,, WARNING, , port: , req iu: 0x, state: 0x, resp iu: 0x, state 0x, Probable Cause Recommended Action Severity Indicates that the information unit response was invalid for the specified command sent. The fabric received an unknown response. This message is rare and usually indicates a problem with the Fabric OS kernel. If this message is due to a one-time event because of the incoming data, the system will discard the frame. If it is due to problems with the kernel, the system will recover by performing a failover. If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the supportSave command and contact your switch service provider. WARNING 11-2 Fabric OS Message Reference Publication Number: 53-1000242-01