HP StorageWorks 2/16V Brocade Fabric OS Message Reference Guide (53-1000242-01 - Page 554

79 SULB-1026 Recommended Action Severity Since the operation may have been started to repair the secondary partition, run the firmwareShow command to verify the versions. If the blade firmware version is still inconsistent with the active CP firmware, firmwareDownload will be started automatically to the blade again. If the blade firmware is the same as the active CP firmware, firmwareDownload has completed successfully on the blade. WARNING SULB-1026 Message AUDIT, , [SULB-1026], WARNING, FIRMWARE, , , , Firmware commit operation started on the blade in slot . Probable Cause Recommended Action Severity firmwareCommit has started on the indicated blade. The operation may be a normal part of firmwareDownload. It can also be started to repair the secondary partition of the blade if the secondary partition is corrupted. No action is required. WARNING SULB-1030 Message AUDIT, , [SULB-1030], WARNING, FIRMWARE, , , , The switch has rebooted during relocating the internal firmware image. Probable Cause Recommended Action Severity The error can be caused by unexpected disruption of firmwareDownload command, for exampling powering the switch off and on in the middle of a firmwareDownload. This error can also be caused by persistent storage hardware failure, or a software error. firmwareDownload process will continue after the switch is rebooted. So continue to run the firmwareDownloadStatus command to monitor the progress. However, if this problem persists, contact the service provider for further actions. WARNING SULB-1034 Message AUDIT, , [SULB-1034], ERROR, FIRMWARE, , , , Firmwaredownload timed out. 79-12 Fabric OS Message Reference Publication Number: 53-1000242-01