HP StorageWorks 2/16V Brocade Fabric OS Message Reference Guide (53-1000242-01 - Page 86

2 AUTH-1025 AUTH-1025 Message , [AUTH-1025], ,, ERROR, , Failed to get during : port Probable Cause Recommended Action Severity Indicates the authentication process failed to get the expected information during the specified authentication phase. Usually this problem is transient. The authentication might fail. Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and switchEnable commands. If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the supportSave command and contact your switch service provider. ERROR AUTH-1027 Message , [AUTH-1027], ,, ERROR, , Failed to select during : value port . Probable Cause Recommended Action Severity Indicates that the authentication process failed to select an authentication value (that is, DH Group, hash value, or protocol type) from a receiving payload for the specified authentication phase. This indicates that the local switch does not support the specified authentication value. Check the authentication configuration and reset the supported value if needed using the authUtil command. Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and switchEnable commands. If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the supportSave command and contact your switch service provider. ERROR AUTH-1028 Message , [AUTH-1028], ,, ERROR, , Failed to allocate for : port 2-8 Fabric OS Message Reference Publication Number: 53-1000242-01