HP StorageWorks 2/16V Brocade Fabric OS Message Reference Guide (53-1000242-01 - Page 431

SEC-1153 58 SEC-1153 Message , [SEC-1153], ,, INFO, , Error in RCA: RCS is not supported Probable Cause Recommended Action Severity Indicates that RCS is not supported. Run the rcsInfoShow command to view RCS capability on the fabric. RCS must be capable on all switches in the fabric to be enabled. If all switches are capable, it is automatically enabled. For any switch that does not support RCS, obtain the latest firmware version from your switch supplier, and run the firmwareDownload command to upgrade the firmware. If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the supportSave command and contact your switch service provider. INFO SEC-1154 Message , [SEC-1154], ,, INFO, , PID change failed: . Probable Cause Indicates that either the defined or the active policy could not be updated. If the policy database is very large, it might not be able to change the index/area because the new policy database exceeds the maximum size. This message can also be caused when the switch is short of memory. The status values can be either defined, active, or both. A negative value means that a policy set was failed by the daemon. Recommended Reduce the size of the policy database. Action Severity INFO SEC-1155 Message , [SEC-1155], ,, INFO, , PID change failed: . Probable Cause Indicates that either the defined or active policy was too large after modifying the index/area ID. The status values can be either defined, active, or both. A negative value means that a policy set was failed by the daemon. Fabric OS Message Reference Publication Number: 53-1000242-01 58-37