HP StorageWorks 2/16V Brocade Fabric OS Message Reference Guide (53-1000242-01 - Page 127

EM-1017 9 Severity If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the supportSave command and contact your switch service provider. WARNING EM-1017 Message , [EM-1017], ,, WARNING, , Uncommitted WWN change detected. Cold reboot required. Probable Cause Recommended Action Severity Indicates that a user did not commit a changed WWN value prior executing a reboot, power cycle, or firmwareDownload operation. Change and commit the new WWN value. WARNING EM-1018 Message , [EM-1018], , FFDC, CRITICAL, , CP blade in slot failed to retrieve current chassis type (//0x). Probable Indicates that there was a failure to read the chassis type from the system. Cause Recommended Verify that the CP blade is operational and is properly seated in its slot. Action Severity CRITICAL EM-1019 Message , [EM-1019], ,, WARNING, , Current chassis configuration option () is not compatible with standby firmware version (Pre 4.4), cannot allow HA Sync. Probable Cause Indicates that the current chassisConfig option is not supported by the firmware on the standby CP. This is true even if the standby comes up and appears to be operational. HA synchronization of the CPs will not be allowed. Fabric OS Message Reference 9-7 Publication Number: 53-1000242-01