HP StorageWorks 2/16V Brocade Fabric OS Message Reference Guide (53-1000242-01 - Page 129

EM-1031 9 EM-1031 Message , [EM-1031], ,, ERROR, , ejector not closed Probable Cause Recommended Action Severity Indicates that the environmental monitor (EM) has found a switch blade that is inserted, but the ejector switch is not closed. The blade in the specified slot is treated as not inserted. Close the ejector switch (raise the slider in most blades, or completely screw in the upper thumbscrew for the FC4-48 port blade) if the FRU is intended for use. Refer to the appropriate hardware manual for instructions on inserting the switch blades. ERROR EM-1033 Message , [EM-1033], ,, ERROR, , CP in set to faulty because CP ERROR asserted Probable Cause Recommended Action Severity Indicates that the standby CP has been detected as faulty. The High Availability feature will not be available. This message occurs every time the other CP reboots, even as part of a clean warm failover. In most situations, this message is followed by the EM-1047 message, and no action is required for the CP; however, you might want to find out why the failover occurred. If the standby CP was just rebooted, wait for the error to clear (run slotShow to determine if it has cleared). Watch for the EM-1047 message to verify this error cleared. If the standby CP continues to be faulty or if it was not intentionally rebooted, check the error logs on the other CP (using the errDump command) to determine the cause of the error state. Try reseating the FRU. If the message persists, replace the FRU. ERROR EM-1034 Message , [EM-1034], ,, ERROR, , set to faulty, rc= Probable Cause Recommended Action Indicates that the specified FRU has been marked as faulty for the specified reason. Try reseating the FRU. Fabric OS Message Reference 9-9 Publication Number: 53-1000242-01