HP StorageWorks 2/16V Brocade Fabric OS Message Reference Guide (53-1000242-01 - Page 98

3 BL-1014 Recommended Action Severity Make sure to capture the console output during this process. Check for a faulty cable, SFP, or device attached to the specified port. On a bladed switch, run the slotPowerOff and slotPowerOn commands. On a nonbladed switch, reboot or power cycle the switch. If the message persists, replace the blade. ERROR BL-1014 Message , [BL-1014], ,, ERROR, , bport port int. is disabled. status=0x Probable Cause Recommended Action Severity Indicates that the port generated an excessive number of interrupts that might prove fatal to the switch operation. The port is disabled to prevent the CP from becoming too busy. The bport is the blade port; this number might not correspond to a user port number. Make sure to capture the console output during this process. On a bladed switch, run the slotPowerOff and slotPowerOn commands. On a nonbladed switch, reboot the switch. Run the systemVerification command to determine if there is a hardware error. If there is a hardware error, if the slotPowerOff or slotPowerOn fails on the bladed switch or if errors are encountered again: • On the SilkWorm 12000, 24000, and 48000, replace the blade FRU. • On the SilkWorm 3900, replace the motherboard FRU. • On the SilkWorm 200E, 3016, 3250, 3850, or 4100, replace the switch. ERROR BL-1015 Message , [BL-1015], ,, ERROR, , bport port is faulted. status=0x Probable Cause Recommended Action Indicates that the port generated an excessive number of interrupts that might prove fatal to the switch operation. The port is disabled to prevent the CP from becoming too busy. The bport is the blade port; this number might not correspond to a user port number. Make sure to capture the console output during this process. 3-6 Fabric OS Message Reference Publication Number: 53-1000242-01