HP StorageWorks 2/16V Brocade Fabric OS Message Reference Guide (53-1000242-01 - Page 146

11 FABR-1014 Probable Cause Recommended Action Severity Indicates that there is not enough memory in the switch for the fabric module to allocate. This message is rare and usually indicates a problem with the Fabric OS. The system will recover by failing over to the standby CP. If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the supportSave command and contact your switch service provider. CRITICAL FABR-1014 Message , [FABR-1014], , FFDC, ERROR, , Port Disabled: Insistent Domain ID could not be obtained. Principal Assigned Domain ID = Probable Cause Recommended Action Severity Indicates that the specified port received an RDI (request domain ID) accept message containing a principal-switch-assigned domain ID that is different from the insistent domain ID (IDID). FICON mode requires an insistent domain ID. If an RDI response has a different domain ID, then the port is disabled. Run the configShow command to view the fabric.ididmode. A 0 means the IDID mode is disabled; a 1 means it is enabled. Set the switch to insistent domain ID mode. This mode is set under the configure command or in Web Tools on the Switch Admin > configure window. ERROR FABR-1015 Message , [FABR-1015], , FFDC, ERROR, , FICON Insistent DID max retry exceeded: All E-Ports will be disabled. Switch is isolated. Probable Cause Recommended Action Severity Indicates that the application exceeded RDI (request domain ID) requests for the insistent domain ID. All E_Ports are disabled, isolating the specified switch from the fabric. Verify that the insistent domain ID is unique in the fabric and then reenable the E_Ports. Run the fabricShow command to view the domain IDs across the fabric and the configure command to change the insistent domain ID mode. Refer to the Fabric OS Command Reference for more information on these commands. ERROR 11-6 Fabric OS Message Reference Publication Number: 53-1000242-01