HP StorageWorks 2/16V Brocade Fabric OS Message Reference Guide (53-1000242-01 - Page 137

EM-1061 9 EM-1061 Message , [EM-1061], ,, WARNING, , Synchronization halted. Remove all blades of type or upgrade your standby CP, then reboot or run haSyncStart. Probable Cause Recommended Action Severity A blade in the system is not supported by the release on the standby CP. Please remove all blades of this type or upgrade your standby CP. Once an appropriate action is taken, this CP must be rebooted or haSyncStart must be run successfully. Until this is done, the system will remain out of synchronization. WARNING EM-1062 Message , [EM-1062], ,, CRITICAL, , Blade in slot faulted as it exceeds the maximum support limit of blades with Blade ID in the chassis. Probable Cause Recommended Action Severity Too many blades of a particular type are in the system. Please remove the faulted blade. CRITICAL EM-1063 Message , [EM-1063], ,, CRITICAL, , Blade in slot faulted because it exceeds the maximum support limit of blades with Blade IDs in the chassis. Probable Too many blades of a set of particular types are in the system. Cause Recommended Please remove the faulted blade. Action Fabric OS Message Reference Publication Number: 53-1000242-01 9-17