HP StorageWorks 2/16V Brocade Fabric OS Message Reference Guide (53-1000242-01 - Page 551

SULB-1010 79 Upgrade State SUS_PEER_FWC_BEGIN SUS_PEER_FS_CHECK1 SUS_FINISH SUS_COMMIT Code 0x32 0x33 0x34 0x35 Recommended Action Severity Run the firmwareDownloadStatus command for more information. In a director, when firmwareDownload fails, the command will synchronize the firmware on the two partitions of each CP by starting a firmware commit operation. Wait until this operation completes (about 10 minutes) before attempting another firmwareDownload. In a director, when firmwareDownload fails, the two CPs may end up with different versions of firmware and they may not gain HA sync. In that case, run firmwareDownload single mode (-s) to upgrade the firmware on the standby CP to the same version as the active CP. Then retry firmwareDownload to download the desired version of firmware onto the CPs. Refer to the Fabric OS Administrator's Guide for troubleshooting information. INFO SULB-1010 Message AUDIT, , [SULB-1010], INFO, FIRMWARE, , , , Firmwarecommit failed (status=0x). Probable Cause Recommended Action Severity Indicates that the firmwareCommit failed. The error code provides debugging information. See Table 79-3 for more information. Run the firmwareCommit command with "-d" option to provide more debugging information. INFO SULB-1017 Message AUDIT, , [SULB-1017], ERROR, FIRMWARE, , , , Firmwaredownload failed in slot . Probable Cause Indicates that the firmwareDownload failed in the indicated blade. The error can be caused by inconsistent AP blade firmware stored on the active CP. It can also be caused by persistent storage hardware failure. Fabric OS Message Reference Publication Number: 53-1000242-01 79-9