HP StorageWorks 2/16V Brocade Fabric OS Message Reference Guide (53-1000242-01 - Page 549

SULB-1009 79 Error Message Error Code "The pre-install script failed." 0x29 "The platform option is not supported. Run chassisConfig to reset the option first 0x2a and then try firmwareDownload." "Failed to install RPM package." 0x2b "Cannot downgrade directly to this version. Downgrade to an intermediate version 0x2c first and then download the desired version." "Cannot download 5.1 because Device Based Routing policy is not supported by 5.1. 0x2d Use aptPolicy to change the routing policy before proceeding." "Invalid RPM package. Please reload firmware packages on the file server." 0x2e "Cannot downgrade due to presence of blade type 17. Remove or power off these 0x2f blades before proceeding." "Cannot downgrade due to presence of blade type 24. Remove or power off these blades before " 0x30 "Cannot downgrade due to presence of long-distance ports in LS mode. Please remove these settings before proceeding." 0x31 "Network is not reachable. Please verify the IP address of the server is correct." 0x32 The following section explains the causes of some common error messages: 0x12 - Unable to access the required package list file. Check the firmwareDownload help page for a list of possible failure reasons. The cause of this error may be that the package list file (.plist) name has not been specified properly. You need to specify the fully qualified path and file name for the package list file, excluding the /SWBDxx directory name. For example, if /dist/SWBD42/release.plist is a fully qualified path and file name, you need to specify /dist/release.plist as the package list file. The error can also be caused by one of the following conditions: • host is not known to the switch. • host cannot be reached by the switch. • user does not have permission on \fIhost\fR. • pfile does not exist on host. • pfile is not in the right format. • the FTP server is not running on host. • Platform does not support indicated firmware. 0x15 - Failed to download RPM package. If this error occurs immediately after firmwareDownload is started, the firmware on the switch may be two releases older than the requested firmware. Firmwaredownload supports firmware upgrades within two feature releases (a feature release is indicated by a major number and a minor number, for example, X.Y). The following are major upgrade versions for the Fabric OS: v4.0, v4.1, v4.2, v4.4, v5.0, and v5.1. In this case, you will need to upgrade to an intermediate version before downloading the desired version. If this error occurs in the middle of firmwaredownload, the firmware in the file server may be corrupted or there may be a temporary network issue. In this case, retry the firmwaredownload command. If the problem persists, contact your system administrator. Fabric OS Message Reference Publication Number: 53-1000242-01 79-7