HP StorageWorks 2/64 HP StorageWorks Fabric OS 5.x Command Reference Guide (AA - Page 111

cmiTest Verifies the control message interface (CMI) bus between ASICs. Synopsis cmitest [--slot slotnumber][-passcnt count][-txports itemlist][-rxports itemlist][-skip mask] Availability admin Description Use this command to test: • Multiplexed 4-bit CMI point-to-point connection between two ASICs. • Message sent with a bad checksum sets the error and interrupt bits of the destination ASIC. • Message sent with a good checksum does not set any error or interrupt bit in any ASIC pair. The CMI is used to send transmission requests or completion messages between the ASIC transmitter and receiver. NOTE: This command is not supported on the 4/16 SAN Switch, SAN Switch 4/32 and 4/256 SAN Director, which use the Condor ASIC. Options This command has the following options: --slot slotnumber -passcnt count -txports itemlist -rxports itemlist -skip mask Specifies the slot number to test. The default is set to 0 and designed to operate on fixed-port-count products. Specifies the number of test passes to run. By default, the test runs one time. Specifies a list of ports to transmit data. By default, all the ports in the specified slot (--slot) are used. See itemList help pages for further details. Specifies a list of ports to receive data. By default, all the ports in the specified slot (--slot) are used. See itemList for more information. Specifies tests to skip using a bit map as follows: 1 CMI data test (ignore checksum) 2 CMI checksum test 3 Enable all tests Fabric OS 5.x command reference guide 111