HP StorageWorks 2/64 HP StorageWorks Fabric OS 5.x Command Reference Guide (AA - Page 639

snmpConfig Manages the SNMP agent configuration. Synopsis snmpConfig --show | --set | --default [snmpv1 | snmpv3 | accessControl | mibCapability | systemGroup] Availability admin (set, default) all users (display) Description Use this command to manage the configuration of the SNMP agent in the switch. The configuration includes SNMPv1 and SNMPv3 configuration, access control list (ACL) configuration, MIB capability configuration, and system group configuration. It supports set, reset to default, and display operations. If you issue this command with incomplete parameters, it displays the command usage. All values successfully changed by this command take effect immediately and are persistent across power cycles and reboots. For dual-domain systems, this command is specific to the SNMP agent associated with the current switch. SNMPv1 configuration parameters There are six communities, respective trap recipients, and trap recipient severity levels supported by the agent. The first three communities are for read-write (rw) access and the last three are for read-only (ro) access. The default value for the trap recipient of each community is 0.0.0.0. The length of community string should be in range of 2 to 16 characters. The default values for the community strings are: Community 1: Secret C0de Community 2: OrigEquipMfr Community 3: private Community 4: public Community 5: common Community 6: FibreChannel NOTE: When secure mode is enabled, community strings can be changed on the primary FCS switch only and propagate changes across the fabric. For an SNMP management station to receive a trap generated by the agent, the administrator must configure a trap recipient to correspond to the IP address of the management station. In addition, the trap recipient must be able to pass the ACL check, as described in "accessControl configuration parameters" on page 641. Trap recipient severity level The event trap level works in conjunction with an event's severity level. When an event occurs, if its severity level is at or below the set value, the SNMP traps, and event traps (swEventTrap, Fabric OS 5.x command reference guide 639