HP StorageWorks 2/64 HP StorageWorks Fabric OS 5.x Command Reference Guide (AA - Page 127

RSCN Transmission mode Table 7 lists the RSCN Transmission Mode fields and their settings. Table 7 RSCN transmission modes Field Type End-device RSCN Transmission Mode number Domain RSCN to End-device for switch IP address or name change number Default Range 1 0 to 2 0 0 to 1 Descriptions of the RSCN Transmission Mode field values are as follows: End-device RSCN Transmission Mode Values: 0 1 2 RSCN with single PID RSCN with multiple PIDs Fabric RSCN Domain RSCN to End-device for switch IP address or name change Values : 0 Disabled. No domain RSCN is sent to the end-device for the switch IP address or name change. 1 Enabled. Domain RSCN is sent to the end-device for the switch IP address or name change. Arbitrated Loop parameters Table 8 lists the Arbitrated Loop Parameter fields. Table 8 Configure command arbitrated loop settings Field Default Range Send FAN frames? 1 0 or 1 Enable CLOSE on OPEN received? 4 0 to 4 Always send RSCN? 0 0 or 1 Descriptions of the Arbitrated Loop Parameter fields are as follows: Send FAN frames? Enable CLOSE on OPEN received? Always send RSCN? Specifies that fabric address notification (FAN) frames be sent to public loop devices to notify them of their node ID and address. When set to 1, frames are sent; when set to 0, frames are not sent. If this is set, a CLS is returned immediately to an OPN if no buffers are available. This is required for TachLite. Following the completion of loop initialization, a remote state change notification (RSCN) is issued when FL_Ports detect the presence of new devices or the absence of preexisting devices. When set, a RSCN is issued upon completion of loop initialization, regardless of the presence or absence of new or pre-existing devices. Fabric OS 5.x command reference guide 127