HP StorageWorks 2/64 HP StorageWorks Fabric OS 5.x Command Reference Guide (AA - Page 724
trunkDebug
![]() |
View all HP StorageWorks 2/64 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 724 highlights
trunkDebug Debugs a trunk link failure. Synopsis trunkdebug port1 port2 Availability admin Description Use this command to debug a trunk link failure. This command reports one of the following messages, based on the trunking properties of the two specified ports: • Switch does not support trunking • Trunking license required • Trunking not supported in switch interop mode • port port_id is not E_Port • port port_id trunking disabled • port port_id speed is not 2G or 4G • port port_id and port port_id are not on same port group • port port_id and port port_id connect to different switches • port port_id is not a trunking port due to: E_Port being disabled, or trunking might be disabled at remote port • port port_id and port port_id cannot trunk, please check link length to make sure difference is less than 400m Operands This command has the following operands: port1 port2 Specify the area number of port 1. Use the switchShow command to view the area numbers for a port. This operand is required. Specify the area number of port 2. Use the switchShow command to view the area numbers for a port. This operand is required. Examples To debug a trunk connection: switch:admin> trunkdebug 43 44 Switch does not support trunking switch:admin> trunkdebug 62 63 port 62 and 63 are trunked together 724 Fabric OS commands
![](/manual_guide/products/hewlettpackard-storageworks-264-hp-storageworks-fabric-os-5x-command-reference-guide-aarvhvbte-2005-b63918e/724.png)