HP StorageWorks 2/64 HP StorageWorks Fabric OS 5.x Command Reference Guide (AA - Page 660

-spd_mode mode Specify the speed mode for the test. This parameter is used only for Bloom and Condor ASIC-based products, where it controls the speed at which each port is operated. For 1 Gb/s-only products, it is ignored. The exact operation of modes 5 through 8 depends upon the loopback mode selected. When speed modes 5 through 8 are used with cables, they must be connected EVEN to ODD or the test will fail. 0 Run test at 1 Gb/sec, 2 Gb/sec, and 4 Gb/sec. 1 Run test at 1 Gb/sec. 2 Run test at 2 Gb/sec (Bloom default). 4 Run test at 4 Gb/sec (Condor default). For -lb_mode set to 0 or 1, the following speed modes are available to test the speed negotiation: 3 Set all even ports' speed to auto-negotiate; set all odd ports' speed to 1 Gb/sec. 4 Set all even ports' speed to auto-negotiate; set all odd ports' speed to 2 Gb/sec. 5 Set all odd ports' speed to auto-negotiate; set all even ports' speed to 1 Gb/sec. 6 Set all odd ports' speed to auto-negotiate; set all even ports' speed to 2 Gb/sec. For -lb_mode set to 2,3, the following speed modes are available to test FIFO underrun: 3,5 Set all even ports' speed for 2 Gb/s. Set all odd ports' speed to 1 Gb/s. --verbose mode -ports itemlist 4,6 Set all even ports' speed for 1 Gb/s. Set all odd ports' speed to 2 Gb/s. Specify a nonzero value to display more detailed information during the test. This mode should be used for debugging purposes. Specify a list of user ports to test. By default, all of the user ports in the current switch are tested. This option might be used to restrict testing to the specified ports. 660 Fabric OS commands