HP StorageWorks 2/64 HP StorageWorks Fabric OS 5.x Command Reference Guide (AA - Page 740

uRouteShow Displays unicast routing information. Synopsis urouteshow [slotnumber/][portnumber][, domainnumber] Availability all users Description Use this command to display the unicast routing information for a port, as it is known by the FSPF path selection and routing task. The routing information describes how a frame that is received from a port on the local switch is to be routed to reach a destination switch. The following information appears: Local Domain ID In Port Domain Out Port Metric Hops Flags Next (Dom, Port) Domain number of local switch. Port from which a frame is received. Except for the cases in which you perform a port swap or enable extended-edge PID (PID Format 2) on a switch, the value is equal to the Area field displayed by the switchShow command. See HP StorageWorks Fabric OS 5.x Fabric Watch administrator's guide for more information regarding the extended-edge PID format. Destination domain of incoming frame. Port to which the incoming frame is to be forwarded. Except for the cases in which you perform a port swap or enable extended-edge PID (PID Format 2) on a switch, the value is equal to the Area field displayed by the switchShow command. For port swap operations, the value is equal to the Swport field displayed by the portSwapShow command. See HP StorageWorks Fabric OS 5.x Fabric Watch administrator's guide for more information regarding the extended-edge PID format. Cost of reaching the destination domain. Maximum number of hops required to reach the destination domain. Indicates if route is dynamic (D) or static (S). A dynamic route is discovered automatically by the FSPF path selection protocol. A static route is assigned using the command uRouteConfig. Domain and port number of the next hop. These are the domain number and the port number of the switch to which Out Port is connected. The information provided by this command should match what is provided by portRouteShow and topologyShow. Operands This command has the following operands: slotnumber For bladed systems only, specify the slot number of the input port whose routes are displayed, followed by a slash (/). 740 Fabric OS commands