HP StorageWorks 2/64 HP StorageWorks Fabric OS 5.x Command Reference Guide (AA - Page 158

diagShowTime Sets or displays diagnostic show-time mode. Synopsis diagshowtime [mode | -show] Availability admin Description Use this command to enable show-time mode (if the mode value is not 0) or disable the show-time mode (if the mode value is set to 0). The mode is saved in flash memory (and stays in that mode) until the next execution of diagShowTime. The mode becomes active as soon as this command is executed; it does not require a reboot to take effect. Show-time mode, when enabled, causes each test to display elapsed-time messages. It is normally used during burn-in and for test method debugging. NOTE: diagsetshowtime is an alias of diagshowtime. Operands This command has the following optional operands: mode -show Specify 1 (or any nonzero value) to enable show-time mode; specify 0 to disable show-time mode. Specify this operand to display the current mode setting. If no operand is specified, the current value is displayed. Examples To enable show-time mode: switch:admin> diagshowtime Show Time mode is 0 (Disabled). switch:admin> diagshowtime 1 Config update Succeeded Show Time mode is now 1 (Enabled). 158 Fabric OS commands