HP StorageWorks 2/64 HP StorageWorks Fabric OS 5.x Command Reference Guide (AA - Page 611

secTempPasswdSet Sets a temporary password on a remote switch. Synopsis sectemppasswdset domain, "login_name" Availability admin Description Use this command to set a unique temporary password for a given account on a specific switch in the fabric. Use the secTempPasswdReset command to remove the temporary password or reboot the switch. You can change any password on any switch. To change the password of an account that has higher level than that of the current user logged in to the primary FCS switch, you must enter the password of the same level account on the primary FCS switch. The password setup on the target is not persistent and will be reset to the secure fabric-wide setting when this target switch is rebooted or when secTempPasswdReset is run on primary FCS switch. Each switch has four accounts: root, factory, admin, and user. Root and factory accounts are disabled for non-FCS switches. This command can enable the root or factory account on a non-FCS switch when you specify a password for those accounts. The password should between 8 and 40 characters. NOTE: This command can be issued only from secure mode and only from the primary FCS switch. Operands This command has the following operands: domain login_name Specify the domain of the switch from which the temporary passwords are to be removed. This operand is optional. Specify the name of the login account from which the temporary password are removed. This operand is optional. Example To set the password on a remote switch with a Domain of 2: switch:admin> sectemppasswdset 2, "root" Please provide password of root on primary FCS switch in order to change this password: ******** Set remote switch root password: ******** Re-enter new password: ******** Account root has been successfully enabled on domain 2 Fabric OS 5.x command reference guide 611