HP StorageWorks 2/64 HP StorageWorks Fabric OS 5.x Command Reference Guide (AA - Page 466

portCfgSpeed Configures the port speed level. Synopsis portcfgspeed [slotnumber/]portnumber speed_level Availability admin Description Use this command to configure the speed of a port to a particular level. After this command is issued, the port is disabled and enabled so that the port comes up with the new speed setting. The configuration is saved in the flash memory and is persistent across switch reboot or power cycle. If the command is specified without an operand, you are prompted to enter the speed value. Press Ctrl+D to cancel the configuration update. The output of the portShow command displays the current achieved speed of a port and the portCfgShow command displays the user-desired speed setting for a port. Operands This command has the following operands: slotnumber portnumber speed_level For bladed systems only, specify the slot number of the port to be configured, followed by a slash (/). Specify a port number to be configured, relative to its slot for bladed systems. Use switchShow to display a list of valid ports. Specify the speed of a port. This operand is required. Valid values are one of the following: 0 Autosensing mode. The port automatically configures for the highest speed. 1 1-Gb/s mode. The port is at fixed speed of 1 Gb/s. 2 2-Gb/s mode. The port is at fixed speed of 2 Gb/s. 4 4-Gb/s mode. The port is at fixed speed of 4 Gb/s. Examples To configure the speed of a port to 2 Gb/s: switch:admin> portcfgspeed 2/3, 2 See also portCfgShow portShow switchCfgSpeed 466 Fabric OS commands