HP StorageWorks 2/64 HP StorageWorks Fabric OS 5.x Command Reference Guide (AA - Page 238

NOTE: This command is not supported on the HP StorageWorks 4/8 or 4/16 SAN switch, the HP StorageWorks SAN Switch 4/32, or the HP StorageWorks 4/256 SAN Director, which use the Condor ASIC. Operands This command has the following operands: --slot slotnumber -passcnt passcnt -txports itemlist -scamoff offset -dcamoff offset -fdefoff offset Specify the slot number on which the diagnostic operates. The port specified are relative to this slot number. The default is 0 and designed to operate on fixed-port-count products. Specify the number of times to perform this test. The default value is 1. Specify the user port numbers to perform this test. All user ports are set by default. Specify the program location to write SCAM test data in SCAM memory. The default value is 0. The maximum offset number is set if the specified number is larger than the limit. Specify the program location to write DCAM test data in DCAM memory. The default value is 0. The maximum offset number is set if the specified number is larger than the limit. Specify the program location to write filter test definition data in filter definition memory. The default value is 0. The maximum offset number is set if the specified number is larger than the limit. Examples To run a frame filter test: switch:admin> filtertest -txports 3/1-3/3 Running filtertest Test Complete: filtertest Pass 1 of 1 Duration 0 hr, 0 min & 2 sec (0:0:2:679). passed. Diagnostics When it detects failures, the subtest might report one or more of the following error messages: DIAG-ACTTEST DIAG-FLTINIT DIAG-FLTRCV DIAG-FLTXMIT DIAG-NUMTEST See the HP StorageWorks Fabric OS 5.x diagnostics and system error messages reference guide for more information. See also itemList 238 Fabric OS commands