HP StorageWorks 2/64 HP StorageWorks Fabric OS 5.x Command Reference Guide (AA - Page 30

Trap recipient severity level The trap severity level is associated with each trap recipient IP address. The event trap level is in conjunction with the event's severity level. When an event occurs and if its severity level is at or below the set value, the SNMP event traps (swEventTrap, swFabricWatchTrap, and connUnitEventTrap) are sent to the trap recipients. By default, this value is set to 0, implying that no such traps are sent. Possible values are as follows: 0 none 1 critical 2 error 3 warning 4 informational 5 debug See errModuleShow for related information. The ACL check is as follows: there are six ACLs to restrict SNMP get/set/trap operations to hosts under a host-subnet-area. Host-subnet-area is defined by comparing nonzero IP octets. For example, an ACL of 192.168.64.0 enables access by any hosts that start with the specified octets. The connecting host is enabled to set each host-subnet-area to be read-write or read-only. The highest privilege matched out of six entries is given to the access. The ACL check is turned off when all six entries contain 0.0.0.0. NOTE: When secure mode is enabled, the access control list feature is incorporated into the WSNMP and RSNMP security policies. Community strings can be changed on the primary FCS switch only and will propagate changes across the fabric. Operands none Examples To modify the SNMP configuration values: switch:admin> agtcfgset Customizing MIB-II system variables ... At each prompt, do one of the followings: o to accept current value, o enter the appropriate new value, o to skip the rest of configuration, or o to cancel any change. (continued on next page) 30 Fabric OS commands