HP StorageWorks 2/64 HP StorageWorks Fabric OS 5.x Command Reference Guide (AA - Page 153
diagSetBurnin
View all HP StorageWorks 2/64 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 153 highlights
diagSetBurnin Initializes the blade for a burn-in run. Synopsis diagsetburnin [--slot slotnumber][script | -current] Availability admin Description This sets up the blade burn-in parameters for the registered burn-in script. The burn-in will start at the next run of power-on self-test (POST) on the designated blades. The errors and activity logs are stored in flash memory. The activity log of the script is saved in /var/log/scriptname.slot.log. The errors produced are available from the burninErrShow command on a per-blade basis. When power cycles occur, the burn-in activity is restarted at the test that was interrupted at the time of the power cycle. This command does not require a reboot to take effect. NOTE: Boards must be installed prior to running this command and diagSetCycle must be run prior to diagSetBurnin if you want to use both commands. NOTE: HP StorageWorks recommends running the burninErrClear command prior to running diagSetBurnin and diagSetCycle. Operands This command has the following operands: --slot slotnumber script -current Specify which slot number to update. If this option is not specified at all, then all slots on the switch are set up for burn-in. Specify the name of the burn-in script to run. Set the name of burn-in script to current burn-in script. Examples To set the burn-in script and mode: switch:admin> diagsetburnin --slot 1 -current existing script is: /fabos/share/switchess.sh Burnin mode is Enabled. Removing all log files in /var/log for slot 1 Slot 1 burnin name is now /fabos/share/switchess.sh Config update Succeeded See also burninErrShow diagSetCycle Fabric OS 5.x command reference guide 153