HP StorageWorks 2/64 HP StorageWorks Fabric OS 5.x Command Reference Guide (AA - Page 146

diagFailLimit Sets the diagnostics fail limit. Synopsis diagfaillimit [limit | -show] Availability admin Description Use this command to set the diagnostics fail limit to a specified value. The fail limit controls the number of failures before certain diagnostic test methods aborts. The exact use of this configuration setting depends on the test method. The fail limit is saved in flash memory and stays set until the next execution of diagFailLimit. The new fail limit becomes active as soon as this command is executed; it does not require a reboot to take effect. Operands This command has the following operands: limit -show Specify the number of failures before a diagnostic test aborts. The limit value must be 1 or greater. This operand is optional. Specify this operand to display the current fail limit setting. This operand is optional. If no operand is specified, the current value is displayed. Examples To change the fail limit from 1 to 5: switch:admin> diagfaillimit -show Fail Limit is 1. switch:admin> diagfaillimit 5 Fail Limit is now 5. Config update Succeeded See also none 146 Fabric OS commands