HP StorageWorks 2/64 HP StorageWorks Fabric OS 5.x Command Reference Guide (AA - Page 494

LIP reason LF1 LF2 OL1 OL2 OL3 8001 8002 8003 8004 8005 8006 8007 8008 8009 800a 800b 800c Speed Negotiation States Link Failure: NOS Transmit State Link Failure: NOS Receive State Offline: OLS Transmit State Offline: OLS Receive State Offline: Wait for OLS State Retry loop init Start loop after gaining sync Restart loop after port reset LIP when a loop hangs Restart loop if LIP received when sending out ARB(F0) LIP when an OPN returns Restart loop when LIPs received in OLD_PORT AC state Restart loop if loop not empty but E_Port loopback LIP as requested by the LINIT ELS received LIP as requested by the LPC ELS received Restart loop for QuickLoop looplet setup Restart loop for QuickLoop looplet re-initialization INIT Start negotiation NM Negotiate master WS Wait for signal NF Negotiation follow NC Negotiation complete For a full explanation of the information displayed by this command, see the HP StorageWorks Fabric OS 5.x procedures user guide. Operands This command has the followingoptional Soperands: count saved portid Specify the maximum number of lines to display. Only the most recent count entries are displayed. Specify a nonzero value to display the saved port log from the last switch fault. See upTime for a list of conditions that cause a fault. The count is ignored when displaying the saved log. Specify the area number of port to be displayed. If a port area number is specified, all other ports on the switch are ignored. 494 Fabric OS commands