D-Link DGS-3426P Product Manual - Page 141
RIP Global Settings, RIP Interface Settings, RIP Global Settings window
UPC - 790069291982
View all D-Link DGS-3426P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 141 highlights
xStack® DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch RIP Global Settings To setup RIP for the IP interfaces configured on the Switch, the user must first globally enable RIP and then configure RIP settings for the individual IP interfaces. To globally enable RIP on the Switch, click Administration > RIP > RIP > RIP Global Settings, as shown below. Figure 2 - 161 RIP Global Settings window To enable RIP, simply use the pull-down menu, select Enabled and click Apply. RIP Interface Settings RIP settings are configured for each IP interface on the Switch. This window appears in table form listing settings for IP interfaces currently on the Switch. To configure RIP settings for an individual interface, click on the hyperlinked Interface Name. To view this window, click Administration > RIP > RIP > RIP Interface Settings, as shown below. Figure 2 - 162 RIP Interface Settings window Click the hyperlinked name of the interface to configure the settings for RIP, which will give access to the following window: Figure 2 - 163 RIP Interface Settings - Edit window The following RIP interface settings can be applied to each IP interface: Parameter Description Interface Name The name of the IP interface on which RIP is to be setup. This interface must be previously configured on the Switch. 132