D-Link DGS-3426P Product Manual - Page 73

xStack® DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch DHCP/BOOTP Relay Interface Settings This window allows the user to set up a server, by IP address, for relaying DHCP/ BOOTP information. The user may enter a previously configured IP interface on the Switch that will indicate which interface is able to support the dhcp relay function. Properly configured settings will be displayed in the BOOTP Relay Table at the bottom of the following window, once the user clicks the Add button under the Apply heading. The user may add up to four server IPs per IP interface on the Switch. To view this window, click Administration > DHCP/BOOTP Relay > DHCP/BOOTP Relay Interface Settings as shown below. Figure 2 - 63 DHCP/BOOTP Relay Interface Settings window The following parameters can be configured or viewed: Parameter Description Interface The IP interface on the Switch that will be connected directly to the client. Server IP Enter the IP address of the DHCP/BOOTP server. Up to four server IPs can be configured per IP Interface Click Add to include this Server To remove an entry, click the corresponding button. DHCP Relay Option 60 Default Settings This window allows the user to configure the DHCP Relay Option 60 Default servers. When there are no matching servers found for the packet based on option 60, the relay servers will be determined by the default relay server setting. Similarly, when there is no match found for the packet, the relay servers will be determined based on the default relay servers. To view this window, click Administration > DHCP/BOOTP Relay > DHCP Relay Option 60 Default Settings, as shown below. Figure 2 - 64 DHCP Relay Option 60 Default Settings window The following parameters can be configured: Parameter Description 64