D-Link DGS-3426P Product Manual - Page 205

xStack® DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch LLDP Global Settings This window is used to configure the LLDP Global Settings on the Switch. When LLDP is enabled the Switch can start to transmit, receive and process LLDP packets. The specific function of each port will depend on the per port LLDP settings. LLDP Global State is Disabled by default. To view this window, click L2 Features > LLDP > LLDP Global Settings, as shown below. Figure 3 - 61 LLDP Global Settings window The following parameters can be configured: Parameter Description LLDP Operation State LLDP Forward Message State Message TX Interval (5-32768) Message TX Hold Multiplier (2-10) ReInit Delay (1-10) TX Delay (1-8192) Used to Enable or Disable LLDP on the Switch. When LLDP is disabled this function controls the LLDP packet forwarding message based on individual ports. If LLDP is enabled on a port it will flood the LLDP packet to all ports that have the same port VLAN and will advertise to other stations attached to the same IEEE 802 LAN. This interval controls how often active ports retransmit advertisements to their neighbors. To change the packet transmission interval, enter a value in seconds (5 to 32768). This function calculates the Time-to-Live for creating and transmitting the LLDP advertisements to LLDP neighbors by changing the multiplier used by an LLDP Switch. When the Time-to-Live for an advertisement expires the advertised data is then deleted from the neighbor Switch's MIB. The LLDP reinitialization delay interval is the minimum time that an LLDP port will wait before reinitializing after receiving an LLDP disable command. To change the LLDP Reinit Delay, enter a value in seconds (1 to 10). LLDP TX Delay allows the user to change the minimum time delay interval for any LLDP 196