D-Link DGS-3426P Product Manual - Page 48

xStack® DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch System Log Source Interface Settings This window may be used to choose a method for which to save the switch log to the flash memory on the Switch. To view this window, click Administration > System Log > System Log Source Interface Settings, as shown below. Figure 2 - 33 System Log Save Mode Settings window The following parameters can be configured: Parameter Description Interface Name Enter the name of the interface. IPv4 Address Tick the check box and enter the IPv4 address. Click Apply to add the entry to the Syslog Source Interface Table. Click to remove the corresponding entry. System Severity Settings The Switch can be configured to allow alerts be logged or sent as a trap to an SNMP agent or both. The level at which the alert triggers either a log entry or a trap message can be set as well. Use this window to set the criteria for alerts. The current settings are displayed below the System Severity Table. To view this window, click Administration > System Severity Settings, as shown below. Figure 2 - 34 System Severity Settings window Use the drop-down menus to configure the parameters described below. Parameter Description 39