D-Link DGS-3426P Product Manual - Page 280

xStack® DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch Figure 5 - 44 CPU Interface Filtering Rule Configuration window (IPv6) Configure the following Access Rule Configuration settings for IPv6: Parameter Description Profile ID This is the identifier number for this profile set. Mode Select Permit to specify that the packets that match the access profile are forwarded by the Switch, according to any additional rule added (see below). Select Deny to specify that packets that match the access profile are not forwarded by the Switch and will be filtered. Access ID (1-100) Type in a unique identifier number for this access. This value can be set from 1 to 100. Type Specifies the type of profile that is being created. Class (0-255) Entering a value between 0 and 255 will instruct the Switch to examine the class field of the IPv6 header. This class field is a part of the packet header that is similar to the Type of Service (ToS) or Precedence bits field of IPv4. Flow Label Configuring this field, in hex form, will instruct the Switch to examine the flow label field of the IPv6 header. This flow label field is used by a source to label sequences of packets such as nondefault quality of service or real time service packets. Source IPv6 Address The user may specify an IP address mask for the source IPv6 address by entering the IP address mask, in hex form. Destination IPv6 The user may specify an IP address mask for the destination IPv6 address by and entering the Address IP address mask, in hex form. Port Enter a port or range of ports. Time Range Click the check box and enter the name of the Time Range settings that has been previously configured in the Time Range Settings window. This will set specific times when this access rule will be implemented on the Switch. Click Apply to implement the changes. To view the settings of a previously correctly configured rule, click View in the CPU Interface Filtering Rule Table to view the following window: 271