D-Link DGS-3426P Product Manual - Page 181

xStack® DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch Replace Source IP This field is used to replace the source IP address of incoming packets sent by the host before being forwarded to the source port. Remap Priority (0-7) Enter a value between 0 and 7. The remap priority is associated with the data traffic to be forwarded on the multicast VLAN. Tick the None check box to use the packet's original priority. Click Apply to implement the settings. To return to the IGMP Snooping Multicast VLAN Table window, click the Show IGMP Snooping Multicast VLAN Entries link. To configure the new Multicast VLAN Group List, click the corresponding Modify button in the IGMP Snooping Multicast VLAN Table which will reveal the following window to be configured. Figure 3 - 38 IGMP Snooping Multicast VLAN Group List Settings Enter an existing VLAN Name and range and click Add. To remove all entries click the Remove All button. To return to the IGMP Snooping Multicast VLAN Table window, click the Show IGMP Snooping Multicast VLAN Entries link. Limited IP Multicast Address Range Settings This window allows the user to specify which multicast address(es) reports are to be received on specified ports on the Switch. This function, also known as IGMP Filtering, will therefore limit the number of reports received and the number of multicast groups configured on the Switch. The user may set an IP address or range of IP addresses to accept reports (Permit) or deny reports (Deny) coming into the specified switch ports. To view this window, click L2 Features > IGMP Snooping > Limited Multicast Address Range Settings, as shown below. To configure Limited IP Multicast Range: Choose the port or sequential range of ports using the From/To port pull-down menus. Use the remaining pull-down menus to configure the parameters described below: 172