D-Link DGS-3426P Product Manual - Page 65

xStack® DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch Backup entries cannot have the same Gateway. Click Apply to implement the changes. To return to the IPv4 Static/Default Route Settings window, click the Show All Static/Default Route Entries link. IPv6 Static/Default Route Settings A static entry of an IPv6 address can be entered into the Switch's routing table for IPv6 formatted addresses. To view this window, click Administration > Static/Default Route Settings > IPv6 Static/Default Route Settings, as shown below. Figure 2 - 52 IPv6 Static/Default Route Settings window This window shows the following values: Parameter Description IPv6 Address/PrefixLen The IPv6 address and corresponding Prefix Length of the IPv6 static route entry. Interface The IP Interface where the static IPv6 route is created. Next Hop Address The corresponding IPv6 address for the next hop Gateway address in IPv6 format. Metric (1-65535) The metric of the IPv6 interface entered into the table representing the number of routers between the Switch and the IPv6 address above. Metric values allowed are between 1 and 65535. Protocol Represents the status for the IPv6 routing table entry. Status Displays whether the entry is Active or Inactive. To remove an entry, click the corresponding button. To add a new entry, click the Add button, revealing the following window to configure: Figure 2 - 53 IPv6 Static Route Settings - Add window The following fields can be set: 56