D-Link DGS-3426P Product Manual - Page 383

xStack® DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch VLAN Status Port This window allows the VLAN status for each of the Switch's ports to be viewed. To view settings for a particular port, enter the port number and click Find. To view this window, click Monitoring > VLAN Status Port, as shown below. Figure 7 - 23 VLAN Status Port window Port Access Control The following screens are used to monitor 802.1X statistics of the Switch, on a per port basis. To view the Port Access Control windows, open the monitoring folder and click the Port Access Control folder. There are six windows to monitor. NOTE: The Authenticator State cannot be viewed on the Switch unless 802.1X is enabled by port or by MAC address. To enable 802.1X, go to the DGS-3400 Web Management Tool window. Authenticator State The following section describes the 802.1X Authenticator State on the Switch. This window displays the Authenticator State for individual ports on a selected device. In Port-based mode if one of the attached hosts is successfully authorized, all hosts on the same port will be granted access to the network. If the port authorization fails, the specified port(s) will continue authenticating. In Host-based mode each user can individually authenticate and access the network. To view this window, click Monitoring > Port Access Control > Authenticator State, as shown below. Figure 7 - 24 Authenticator State window The user may also view this window if any port/host is authenticated. Parameter Description Port List Enter the port list you wish to find. To view all ports tick the Select All Ports check box. 374