Panasonic WJ-ND400K Operating Instructions - Page 194

Network SNMP Use the following procedure to configure settings for using SNMP (Simple Network Management Protocol). Configure these settings when connecting to an SNMP manager and check the status of the recorder. 1 Click the [Network] button on the setup menu. 2 On the sub-menu that appears, click [SNMP]. This will display the "SNMP Setup" window. 3 Configure the settings for each item. Refer to "SNMP settings" table for details about the settings. 4 Click the [Set] button. SNMP settings Item Settings Description Community Name input (Blank♦) Enter the community name to be monitored. • Enter up to 32 single-byte alphanumeric characters and symbols.*1 System name Name input (Blank♦) Enter a name to be used by the SNMP system to manage the recorder. • You can input up to 255 single-byte alphanumeric characters. Location Name input (Blank♦) Enter the location of the recorder. • You can input up to 255 single-byte alphanumeric characters. Contact Address input (Blank♦) Enter contact information (mail address, etc.) for the recorder administrator. • You can input up to 255 single-byte alphanumeric characters. ♦Initial default *1 You can enter the following single-byte alpha-numeric characters and symbols. A B C D E F G H I J K L M N O P Q R S T U V W X Y Z a b c d e f g h i j k l m n o p q r s t u v w x y z 0 1 2 3 4 5 6 7 8 9 65