Canon EOS C700 FF PL EOS C700 EOS C700 PL EOS C700 GS PL EOS C700 FF EOS C700 - Page 204

Preparations Removing the CDX-36150 Recorder 204 1 Press the Q button to turn off the camera. 2 Remove all power sources connected to the recorder (DC IN and battery). 3 Use the hex wrenches supplied with the camera to remove the 6 screws shown in the illustration. • Use the 1/4" (0.64 cm) wrench for the 2 top plate screws closer to the front of the camera and the M4 wrench for the rest of the screws and bolts (top/bottom plates). 4 Remove the reinforcement plate from the recorder. 5 Remove the recorder (A 23). • Follow the procedure to remove the recorder in the same way explained for removing the battery adapter. • Pull out the locking lever on the recorder to remove it from the camera. NOTES • Be careful not to obstruct in any way the recorder's air vents. • To use the camera's DC IN 12V terminal when the recorder is attached to the camera, remove the cover next to the CDX-36150 Recorder's DC IN terminal. Air vents Powering the CDX-36150 Recorder Cover Connect the power supply to the CDX-36150 Recorder before turning on the camera. While the CDX-36150 Recorder is docked with the camera, power is supplied to the camera from the power source connected to the CDX-36150 Recorder. You can also connect a power source directly to the camera's DC IN 12V terminal. 1 Press the camera's Q button to turn off the camera. 2 Connect the power supply (DC IN or battery) to the recorder. • Refer to the CDX-36150 Recorder's Getting Started Guide. 3 Press the camera's Q button to turn on the camera. • The LED on the top of the CDX-36150 Recorder will illuminate in different colors to indicate the recorder's status. Refer to the following table.