Dell PowerEdge FX2 Dell PowerEdge FN I/O Aggregator Command Line Reference Gui - Page 105
Number of Traffic, ETS DCBX Oper
View all Dell PowerEdge FX2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 105 highlights
Command Modes Command History Usage Information EXEC Privilege Version 9.4(0.0) Supported on the FN I/O aggregator. To clear ETS TLV counters, use the clear ets counters interface porttype slot/port command. The following describes the show interface summary command shown in the following example. Field Interface Max Supported TC Group Number of Traffic Classes Description Interface type with stack-unit and port number. Maximum number of priority groups supported. Number of 802.1p priorities currently configured. Admin mode ETS mode: on or off. When on, the scheduling and bandwidth allocation configured in an ETS output policy or received in a DCBX TLV from a peer can take effect on an interface. Admin Parameters ETS configuration on local port, including priority groups, assigned dot1p priorities, and bandwidth allocation. Remote Parameters ETS configuration on remote peer port, including admin mode (enabled if a valid TLV was received or disabled), priority groups, assigned dot1p priorities, and bandwidth allocation. If ETS admin mode is enabled on the remote port for DCBX exchange, the Willing bit received in ETS TLVs from the remote peer is included. Local Parameters ETS configuration on local port, including admin mode (enabled when a valid TLV is received from a peer), priority groups, assigned dot1p priorities, and bandwidth allocation. Operational status (local port) Port state for current operational ETS configuration: • Init: Local ETS configuration parameters were exchanged with the peer. • Recommend: Remote ETS configuration parameters were received from the peer. • Internally propagated: ETS configuration parameters were received from the configuration source. ETS DCBX Oper status Operational status of the ETS configuration on the local port: match or mismatch. 105