Dell PowerEdge FX2 Dell PowerEdge FN I/O Aggregator Command Line Reference Gui - Page 342
iscsi enable, iscsi priority-bits, iscsi profile-compellent
View all Dell PowerEdge FX2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 342 highlights
iscsi enable Globally enable iSCSI optimization. Syntax iscsi enable To disable iSCSI optimization, use the no iscsi enable command. Parameters Defaults Command Modes Command History Usage Information enable Enter the keyword enable to enable the iSCSI optimization feature. Disabled. CONFIGURATION Version 9.4(0.0) Supported on the FN I/O aggregator. This command is supported in Programmable-Mux (PMUX) mode only. When you enable the iSCSI feature using the iscsi enable command, flow control settings are set to rx on tx off on all interfaces. iscsi priority-bits Configure the iSCSI priority advertised for the iSCSI protocol in application priority TLVs. Syntax iscsi priority-bits priority-bitmap To remove the configured iSCSI priority, use the no iscsi priority-bits command. Parameters priority-bitmap Enter the priority-bitmap range. The range is from 1 to FF. Defaults Command Modes Command History Usage Information 0x10 PROTOCOL LLDP Version 9.4(0.0) Supported on the FN I/O aggregator. This command is supported in Programmable-Mux (PMUX) mode only. This command is available at the global level only. iscsi profile-compellent Configure the auto-detection of Dell Compellent arrays on a port. Syntax iscsi profile-compellent 342