Dell PowerEdge FX2 Dell PowerEdge FN I/O Aggregator Command Line Reference Gui - Page 355
Mode of IPv4 Address Assignment : NONE, ARP type: ARPA, ARP Timeout 04:00:00
View all Dell PowerEdge FX2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 355 highlights
Example (Master/Slave) Example (Master/Slave, partial) User Information • Forced-master • Force-slave • Master • Slave • Auto-neg Error - typically indicates that both ends of the node are configured with forced-master or forced-slave. CAUTION: Ensure that one end of your node is configured as forced-master and one is configured as forced-slave. If both are configured the same (that is, forced-master or forced-slave), the show interfaces command flaps between an auto-neg-error and forced-master/slave states. You can display master/slave settings with the show interfaces command. Dell(conf)# int tengig 0/1 Dell(conf-if)#neg auto Dell(conf-if-autoneg)# ? end Exit from configuration mode exit Exit from autoneg configuration mode mode Specify autoneg mode no Negate a command or set its defaults show Show autoneg configuration information Dell(conf-if-autoneg)#mode ? forced-master Force port to master mode forced-slave Force port to slave mode Dell(conf-if-autoneg)# Dell#show interfaces configured TenGigabitEthernet 0/1 is up, line protocol is up Hardware is DellEth, address is 00:1e:c9:de:04:9c Current address is 00:1e:c9:de:04:9c Server Port AdminState is N/A Pluggable media not present Interface index is 33886978 Internet address is not set Mode of IPv4 Address Assignment : NONE DHCP Client-ID :001ec9de049c MTU 12000 bytes, IP MTU 11982 bytes LineSpeed 10000 Mbit Flowcontrol rx on tx off ARP type: ARPA, ARP Timeout 04:00:00 Last clearing of "show interface" counters 03:56:48 Queueing strategy: fifo Input Statistics: ... Both sides of the link must have auto-negotiation enabled or disabled for the link to come up. The following details the possible speed and auto-negotiation combinations for a line between two 10/100/1000 Base-T Ethernet interfaces. Port 0 • auto-negotiation enabled* speed 1000 or auto 355