Dell PowerEdge FX2 Dell PowerEdge FN I/O Aggregator Command Line Reference Gui - Page 370
mac-address-table station-move refresh-arp, show mac-address-table, Parameters, output, Defaults
View all Dell PowerEdge FX2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 370 highlights
Parameters Defaults Command Modes Command History mac-address output interface Enter the 48-bit hexadecimal address in nn:nn:nn:nn:nn:nn format. Enter the keyword output then one of the following interfaces for which traffic is forwarded: • For a Port Channel interface, enter the keywords portchannel then a number. The range is from 1 to 128. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information. vlan vlan-id Enter the keyword vlan then a VLAN ID number from 1 to 4094. Not configured. CONFIGURATION Version 9.4(0.0) Supported on the FN I/O aggregator. This command is supported in Programmable-Mux (PMUX) mode only. mac-address-table station-move refresh-arp Ensure that address resolution protocol (ARP) refreshes the egress interface when a station move occurs due to a topology change. Syntax [no] mac-address-table station-move refresh-arp Defaults none Command Modes CONFIGURATION Command History Version 9.4(0.0) Supported on the FN I/O aggregator. This command is supported in Programmable-Mux (PMUX) mode only. Usage Information For details about using this command, refer to the "NIC Teaming" section of the Layer 2 chapter in the Dell Networking OS Configuration Guide. show mac-address-table Display the MAC address table. Syntax show mac-address-table [dynamic | static] [address mac-address | interface interface | vlan vlan-id] [count [vlan vlan-id] [interface interface-type [slot [/port]]]] Parameters dynamic (OPTIONAL) Enter the keyword dynamic to display only those MAC addresses the switch dynamically learns. Optionally, you can also add one of these combinations: 370