Dell PowerEdge FX2 Dell PowerEdge FN I/O Aggregator Command Line Reference Gui - Page 357
G - GVRP tagged, M - Vlan-stack, Mirroring VLANs, P - Primary, C - Community, I - Isolated
View all Dell PowerEdge FX2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 357 highlights
Example The following describes the do show interfaces command shown in the following example. This example shows output with "Hybrid" as the newly added value for 802.1QTagged. The options for this field are: • True - port is tagged • False - port is untagged • Hybrid - port accepts both tagged and untagged frames The following describes the interface vlan command shown in the following example. This example shows unconfiguration of the hybrid port using the no portmode hybrid command. NOTE: Remove all other configurations on the port before you can remove the hybrid configuration from the port. Dell(conf-if-te-0/2)#show config ! interface TenGigabitEthernet 0/2 mtu 12000 portmode hybrid switchport flowcontrol rx on tx off ! protocol lldp advertise management-tlv management-address system-name dcbx port-role auto-downstream no shutdown Dell(conf-if-te-0/2)#vlan tagged 5 Dell(conf-if-te-0/2)#vlan untagged 10 Dell(conf-if-te-0/2)# Dell(conf-if-te-0/2)#do show vlan Codes: * - Default VLAN, G - GVRP VLANs, R - Remote Port Mirroring VLANs, P - Primary, C - Community, I - Isolated O - Openflow Q: U - Untagged, T - Tagged x - Dot1x untagged, X - Dot1x tagged o - OpenFlow untagged, O - OpenFlow tagged G - GVRP tagged, M - Vlan-stack, H - VSN tagged i - Internal untagged, I - Internal tagged, v - VLT untagged, V - VLT tagged NUM Status Description Q Ports * 1 Active U Po128(Te 0/9-11) 0/1,3-8 5 Active T Po128(Te 0/9-11) 10 Active T Po128(Te 0/9-11) Dell(conf-if-te-0/2)# U Te T Te 0/2 U Te 0/2 357