Dell PowerEdge FX2 Dell PowerEdge FN I/O Aggregator Command Line Reference Gui - Page 362
ip igmp query-interval, ip igmp query-max-resp-time
View all Dell PowerEdge FX2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 362 highlights
Parameters Defaults Command Modes Command History To return to the default value, use the no ip igmp querier-timeout command. seconds 125 seconds INTERFACE Enter the number of seconds the router must wait to become the new querier. The range is from 60 to 300. The default is 125 seconds. Version 9.4(0.0) Supported on the FN I/O aggregator. This command is supported in Programmable-Mux (PMUX) mode only. ip igmp query-interval Change the transmission frequency of IGMP general queries the Querier sends. Syntax ip igmp query-interval seconds To return to the default values, use the no ip igmp query-interval command. Parameters Defaults Command Modes Command History seconds 60 seconds INTERFACE Enter the number of seconds between queries sent out. The range is from 1 to 18000. The default is 60 seconds. Version 9.4(0.0) Supported on the FN I/O aggregator.. This command is supported in Programmable-Mux (PMUX) mode only. ip igmp query-max-resp-time Set the maximum query response time advertised in general queries. Syntax ip igmp query-max-resp-time seconds To return to the default values, use the no ip igmp query-max-resp-time command. Parameters Defaults seconds 10 seconds Enter the number of seconds for the maximum response time. The range is from 1 to 25. The default is 10 seconds. 362