Dell PowerEdge FX2 Dell PowerEdge FN I/O Aggregator Command Line Reference Gui - Page 317
show qos dcb-map
View all Dell PowerEdge FX2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 317 highlights
show qos dcb-map Display the DCB parameters configured in a specified DCB map. Syntax show qos dcb-map map-name Parameters map-name Displays the PFC and ETS parameters configured in the specified map. Command Modes • EXEC • EXEC Privilege Command History Usage Information Version 9.4(0.0) Supported on the FN I/O aggregator. Use the show qos dcb-map command to display the enhanced transmission selection (ETS) and priority-based flow control (PFC) parameters used to configure server-facing Ethernet ports. Example The following table describes the show qos dcb-map output shown in the example below. Field State PFC Mode PG TSA BW PFC Priorities Description Complete: All mandatory DCB parameters are correctly configured. In progress: The DCB map configuration is not complete. Some mandatory parameters are not configured. PFC configuration in DCB map: On (enabled) or Off. Priority group configured in the DCB map. Transmission scheduling algorithm used by the priority group: Enhanced Transmission Selection (ETS). Percentage of bandwidth allocated to the priority group. PFC setting for the priority group: On (enabled) or Off. 802.1p priorities configured in the priority group. Dell# show qos dcb-map dcbmap2 State :Complete PfcMode:ON PG:0 TSA:ETS BW:50 PFC:OFF Priorities:0 1 2 4 5 6 7 PG:1 TSA:ETS BW:50 PFC:ON Priorities:3 317