Dell PowerEdge FX2 Dell PowerEdge FN I/O Aggregator Command Line Reference Gui - Page 458
system-mac, unit-id, Vlan IPV4 Multicast Status, Vlan-ID, Local Status, Peer Status, Active
View all Dell PowerEdge FX2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 458 highlights
Vlan IPV4 Multicast Status Vlan-ID Local Status -------- ------------ 4094 Active Dell# Peer Status ----------- Inactive system-mac Reconfigure the default MAC address for the domain. Syntax Parameters system-mac mac-address mac-address Enter the system MAC address for the VLT domain. Defaults Command Modes Command History Not configured. VLT DOMAIN Version 9.4(0.0) Supported on the FN I/O aggregator. This command is supported in Programmable-Mux (PMUX) mode only. Usage Information When you create a VLT domain on a switch, Dell Networking OS automatically creates a VLT-system MAC address used for internal system operations. To reconfigure the default MAC address for the domain by entering a new MAC address in the format nn:nn:nn:nn:nn:nn, use the system-mac command. You must also reconfigure the same MAC address on the VLT peer switch. unit-id Explicitly configure the default unit ID of a VLT peer switch. Syntax Parameters unit-id [0 | 1] 0 | 1 Configure the default unit ID of a VLT peer switch. Enter 0 for the first peer or enter 1 for the second peer. Defaults Command Modes Command History Automatically assigned based on the MAC address of each VLT peer. The peer with the lower MAC address is assigned unit 0; the peer with the higher MAC address is assigned unit 1. VLT DOMAIN Version 9.4(0.0) Supported on the FN I/O aggregator. This command is supported in Programmable-Mux (PMUX) mode only. 458